第二组 The only attention that heat exchanger should
第二组
The only attention that heat exchanger should require is to ensure that the heat transfer surfaces remain substantially clean and the flow passages generally clear of obstruction. Indication that undue fouling is occurring is given by a progressive increase in the temperature difference between the two fluids, over a period of time, usually accompanied by a noticeable rise in pressure loss at a given flow.
Fouling on the sea-water side is the most usual cause of deterioration in performance. The method of cleaning the sea water-side surfaces depends on the type of heat exchanger. With shell-and-tube heat exchangers, the removal of the header covers or, m the case of the smaller heat exchangers, the headers themselves, will provide access to the tubes. Obstructions, dirt, scale etc., can then be removed, using the tools provided by the heat exchanger manufacturer. Flushing through with fresh water is recommended before a heat exchanger is returned to service. In some applications, such as piston oil cooling, progressive fouling may take place on the outside of the tubes. Most manufactures recommend a chemical flushing pr6cess to remove this in situ~ without dismantling the heat exchanger.
Plate heat exchangers may be cleaned by unclamping the stack of plates and mechanically cleaning the surface of each plate as recommended by the manufacturers. The plate seals may require replacement from time to time and here the manufacturers&39; instructions should be closely followed
By which of the following indication, can we conclude that the lube oil-sea water heat exchanger is unduly fouled?
A.the heat exchanger lube oil inlet temperature lowering
B.the heat exchanger sea-water outlet pressure rise
C.the heat exchanger temperature difference between lube oil and sea water increasing
D.the heat exchanger pressure difference between sea water inlet and outlet decreasing
请帮忙给出正确答案和分析,谢谢!
参考解答
正确答案:C
相似问题
Which of the following components are used to conv
Which of the following components are used to convert alternating current produced in the generator windings to direct curren
why is quick closing valves important to in engine
why is quick closing valves important to in engine room machineries ?how are they operated ?请帮忙给出正确答案和分析,谢谢!
If anything abnormal be found on the load change o
If anything abnormal be found on the load change of main engine when the ship is entering in shallow waterway, before taki
职业道德的特点主要表现在以()等方面。A.范围上的特殊性B.内容上的稳定性C.形式上的多样性 具体性
职业道德的特点主要表现在以()等方面。A 范围上的特殊性B 内容上的稳定性C 形式上的多样性、具体性D 强烈的纪律性此题为多项选择题。请帮忙给出正确答案
引起活塞顶部局部过热的原因是_______和燃油雾化不良 火焰直接接触等A.超负荷B.冷却不良C.喷
引起活塞顶部局部过热的原因是_______和燃油雾化不良、火焰直接接触等A 超负荷B 冷却不良C 喷油定时不正D 冷却侧积垢请帮忙给出正确答案和分析,谢谢!
